Snapper Immobilizer E-Lock with drivercards
TOP
Snapper Immobilizer E-Lock with Drivercard
The contactless Snapper immobilizer with Drivercard is very easy to retrofit. It offers the option of interrupting electrical consumers such as the starter motor, fuel pump or other
relevant electrical circuits. The immobilizer is simply connected to the circuit to be interrupted. The system is activated 20 seconds after the ignition is switched off.
The transponder technology of the Drivercard recognizes when you approach your vehicle with the Drivercard. The immobilizer is deactivated without contact within a radius of 5 meters. If the Drivercard is not in the vehicle, the system interrupts the circuit. It is then no longer possible to continue driving. The engine can only be started if the driver card is recognized.
A CR2032 button cell will power the Divercard for several years, depending on use.
IDEAL PROTECTION FOR VEHICLES WITH KEYLESS GO
EU Approval
The contactless Snapper immobilizer with Drivercard is very easy to retrofit. It offers the option of interrupting electrical consumers such as the starter motor, fuel pump or other
relevant electrical circuits. The immobilizer is simply connected to the circuit to be interrupted. The system is activated 20 seconds after the ignition is switched off.
The transponder technology of the Drivercard recognizes when you approach your vehicle with the Drivercard. The immobilizer is deactivated without contact within a radius of 5 meters. If the Drivercard is not in the vehicle, the system interrupts the circuit. It is then no longer possible to continue driving. The engine can only be started if the driver card is recognized.
A CR2032 button cell will power the Divercard for several years, depending on use.
IDEAL PROTECTION FOR VEHICLES WITH KEYLESS GO
EU Approval
Functions
- Immobilizer with 1x integrated 10 Amp. Relay
- Control for second circuit interruption by means of external relay
- Automatic disarming by detecting the drivercard in a radius up to 5m
- Automatic arming after 20 seconds
- Programming by service button
- Power saving mode by built-in motion sensor of the drivercard after 5 minutes
- Status LED
Scope of delivery:
Control unit with cable set
2 x drivercards
2 x battery
Operating instructions / manual
Control unit with cable set
2 x drivercards
2 x battery
Operating instructions / manual
Technical data:
- Operating voltage : 12 volt
- Quiescent current : 15 mA
- Working temperature : - 30 to + 80 °C
- Switching capacity : 12 V - 10 Amp.
- Up to 4 transponders programmable
- Frequency : 868 MHz
- Module size : 54 x 46 x 19 mm