Snapper CAN BUS Alarmsystem with Radar sensor
Switched by CAN DATA BUS already present in the car.
Ideal for vehicles with existing factory (original) remote controls.
- No external programming device required! Settings are made directly on the device
- universally applicable in vehicles with CAN DATEN BUS
- Select manufacturer, type and year from list, type in, ready!
- Current manufacturer list in the service forum!
- Anti HiJacking function (not allowed in EU)
- Disconnection of the sensors by service button
- Turn signal control directly but also possible at the hazard light switch (simple 1-cable solution)
- Acoustic acknowledgement tone
- Operation for up to 3 sensors
- Pre-warning adjustable (not approved in EU)
- Connection for second siren and GSM/GPS localization
- Control for comfort closing (automatic closing of windows and sunroof)
- Control of ZV closing if vehicle >50km/h (only possible in some vehicles)
- Connection with only a few wires
- E-approval
- Delivery includes siren, LED, Y-adapter, hood contact and 2-zone microwave / radar sensor!
Technical data:
Rated voltage: +12V
Operating voltage: +9V ... +15V
Power consumption: Standby 20 mA
Disarm 10 mA
Operating temperature: -40°C ... +80°C
Alarm duration: 30 sec.
Ready to receive after standby 25 sec.
PEKATRONIC 2-zone microwave / radar sensor
The 2-zone microwave radar sensor from PEKATRONIC is used for additional protection of the interior. Due to the 2-zone technology an additional pre-warning is possible. The microwave technology allows operation even when the vehicle is open, therefore it is also ideally suited for the protection of convertibles.
Built-in special filter against false alarms caused by high-frequency interference, e.g. from cell phones or other jammers. For the first time, cell phones can remain in the vehicle, an incoming call does not cause a false alarm .
- 2 channel prewarning level system
- first prewarning stage reports movement outside the vehicle
- second stage triggers full alarm!
- each zone adjustable by its own controller
- green LED for pre-alarm
- red LED for main alarm